期刊信息
主管单位:教育部
主办单位:重庆大学
主  编:刘汉龙
地  址:重庆市沙坪坝区沙正街174号 重庆大学期刊社 《土木与环境工程学报》编辑部
邮政编码:400044
电  话:023-65111322;023-65111863
电子邮件:xuebao@cqu.edu.cn
国际标准刊号:ISSN 2096-6717
国内统一刊号:CN 50-1218/TU
邮发代号:78-48
每期定价:¥20
全年定价:¥120
访问统计
  • 您是本站第3424943位读者
  • 今日访问835
引用本文:
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  下载PDF阅读器  关闭
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 107次   下载 46 本文二维码信息
码上扫一扫!
分享到: 微信 更多
防堵塞型透水制品的制备与性能研究
唐静, 赵玉婷, 梁美坤, 贺濒苇, 余意恒, 曾路
重庆大学 材料科学与工程学院, 重庆 400045
摘要:
为改善路面透水性能,聚合物透水混凝土已逐渐广泛用于海绵城市的建设中。试验采用特细砂和环氧树脂制备透水材料,通过控制变量法,分别探讨砂的粒径和聚合物掺量对透水混凝土的抗压强度以及透水系数的影响;并进行了堵塞的模拟实验,基于图像分析透水混凝土的孔径大小,通过观察混凝土的微观结构分析其性能变化规律。实验结果表明,在粒径相同的情况下,随着环氧树脂掺量的增加,环氧树脂透水混凝土的抗压强度逐渐提高,而透水系数逐渐下降;环氧树脂透水混凝土抗压强度会随着较大粒径颗粒复掺含量的增大呈现先增加后下降的趋势,而透水系数呈现不断增大的趋势。当骨料粒径为0.15~0.3 mm,环氧树脂掺量为骨料质量的5%时,制品的平均孔隙率为14%,平均等效直径为214 μm;当粒径为0.15~0.3 mm和0.3~0.6 mm的骨料复掺比例为1:1时,综合效果较好,抗压强度达41.7 MPa,透水系数为1.7 mm/s,制品堵塞4次循环后,透水衰减系数小于20%,防堵塞性能良好。
关键词:  透水制品  骨料粒径  聚合物  防堵塞  孔隙结构
DOI:10.11835/j.issn.2096-6717.2019.081
分类号:TU473.1
基金项目:第九届“重庆大学大学生科研训练计划”项目(CQU-SRTP-2017178)
Study on preparation and performance of anti-blocking pervious products
Tang Jing, Zhao Yuting, Liang Meikun, He Binwei, Yu Yiheng, Zeng Lu
College of Materials Science & Engineering, Chongqing University, Chongqing 400045, P. R. China
Abstract:
In order to improve the permeable performance of pavement,polymer pervious concrete has been widely used in the construction of sponge city. Polymer experiment, special fine sand and epoxy resin were used to prepare materials required in tests. The influence of particle size and polymer content on the compressive strength and permeable coefficient of permeable concrete were discussed by controlling variable method. At the same time, the simulation experiment of blockage is carried out. Based on the image analysis, the pore of the permeable concrete is analyzed. Finally, the mechanism of its performance change is analyzed by observing the microscopic structure of the concrete. The experimental results show that with the increase of the amount of epoxy resin admixture, the compressive strength of epoxy resin permeable concrete increases and the permeable coefficient decreases. The compressive strength of epoxy resin permeable concrete will increase initially and then decrease with the increase of the dosage of the large particle size aggregate. The aggregate blending ratios with particle sizes of 0.15~0.3 and 0.3~0.6 were 1:1, with a compressive strength of 41.7 MPa and a permeation coefficient of 1.7 mm/s,as the best performance. After the product blocks four cycles, the permeability attenuation coefficient is less than 20%, and the anti-blockage performance is satisfactory and promising.
Key words:  pervious concrete  aggregate size  polymers  anti blocking  porosity structure
Copyright@ 2008 All Rights Reserved.
关注微信二维码