真空碳热还原酸浸含钛高炉渣制备TiC分析
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助(51404044);高等学校博士学科点专项科研基金资助项目(20130191110015)。


Preparation of TiC by carbothermal reduction in vacuum and acid leaching process using titanium bearing blast furnace slag
Author:
Affiliation:

Fund Project:

Supported by National Natural Science Foundation of China (51404044) and Research Fund for the Doctoral Program of Higher Education of China (RFDP) (20130191110015).

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    含钛高炉渣中含有20%~30%的TiO 2,是一种附加值较高的二次资源,但在综合利用过程中存在氧化物还原难度大,硅钛难分离,二次污染严重等问题。基于热力学理论基础,采用真空碳热还原联合酸浸工艺处理含钛高炉渣制备TiC。结果表明:真空有助于钛氧化物彻底还原,可实现渣中硅钛彻底分离,减少酸耗量,降低二次污染。真空碳热还原联合酸浸工艺处理含钛高炉渣(TiO 2含量23%左右)制备TiC的最佳条件为:炉渣粒度200目,还原温度1 673 K,渣碳质量比100∶38。

    Abstract:

    Titanium bearing blast furnace slag with 20%-30% titanium dioxide is a valuable second resource. The main problems to utilize the resource are the reduction of the titanium oxides,the separation of titanium and silicon and the second pollution. The main aim of the research is to prepare TiC by the united process of carbothermal reduction in vacuum and acid leaching based on the thermodynamics calculation. The results show that decreasing pressure of the system is helpful for the reduction of the titanium oxides. Titanium and silicon in slag can be separated completely. The second pollution decreases due to evaporation of Mg and SiO produced in vacuum condition. The optimum conditions for the united process to prepare TiC are slag size of 200 mesh, temperature of 1 673 K, and the mass ratio of slag to reductant of 100∶38.

    参考文献
    相似文献
    引证文献
引用本文

胡蒙均,尹方庆,魏瑞瑞,邓青宇,扈玫珑.真空碳热还原酸浸含钛高炉渣制备TiC分析[J].重庆大学学报,2015,38(6):99-106.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2015-07-17
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-01-04
  • 出版日期:
文章二维码