期刊信息
主管单位:国家教育部
主办单位:重庆大学
主  编:
地  址:重庆市沙坪坝正街174号
邮政编码:400030
电  话:023-65102302
电子邮件:xbsg@cqu.edu.cn
国际标准刊号:ISSN 1000-582X
国内统一刊号:CN 50-1044/N
邮发代号:国内78-16 国外 M355
引用本文:
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  下载PDF阅读器  关闭
←前一篇|后一篇→ EndNote   BibTeX  过刊浏览    高级检索
本文已被:浏览 73次   下载 19 本文二维码信息
码上扫一扫!
分享到: 微信 更多
双离合自动变速器产热与传热仿真建模及试验验证
宋勇1, 张志伟1, 阮登芳1,2
1.重庆大学 汽车工程学院, 重庆 400044;2.重庆大学 机械传动国家重点实验室, 重庆 400044
摘要:
为了预测双离合自动变速器在工作过程中各热源的产热量及元件的温度状况,基于热网络理论建立了变速器轴承受力计算、内部热源产热量计算及传热计算耦合仿真模型,并对变速器在稳态与瞬态工况下的产热与传热进行了仿真计算与试验验证。结果表明,在稳态工况下,变速器的总产热量仿真值与试验测试结果吻合较好,瞬态工况下的变化趋势与试验测试结果一致;各测试点温度在稳态与瞬态工况下的仿真值与试验测试结果均吻合较好,模型具有较高的计算精度。
关键词:  双离合自动变速器  产热  传热  仿真  试验验证
DOI:10.11835/j.issn.1000-582X.2020.02.003
分类号:TH132
基金项目:重庆市重点产业共性关键技术创新专项资助项目(CSTC2017ZDCY-ZDYF0139)。
Modeling and validation of power loss and heat transfer of a dual clutch transmission
SONG Yong1, ZHANG Zhiwei1, RUAN Dengfang1,2
1.School of Automotive Engineering, Chongqing University, Chongqing 400044, P. R. China;2.The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing 400044, P. R. China
Abstract:
In order to predict the heat generation of each heat source and the temperature distribution of components of a dual clutch transmission, a coupled model to simulate the bearing forces, power loss and heat transfer of the transmission was developed based on the theory of thermal network, and validated by comparing the simulation results of the total power loss and the temperature of some chosen tested points under steady and transient operation conditions with the experimental results. The results show that the numerical total power loss is in good agreement with the test results under steady operation condition, and the variation trend of the numerical results under transient condition is same as the test results; the numerical temperature of each tested point under steady and transient working conditions is in good agreement with the test results.
Key words:  dual clutch transmission  power loss  heat transfer  simulation  experimental validation
Copyright@ 2008 All Rights Reserved.